rfc9884v2.txt		rfc9884.txt
	skipping to change at line 175 ¶		skipping to change at line 175 ¶
	Table 1: Sub-TLVs for PSID Checks		Table 1: Sub-TLVs for PSID Checks
	As specified in Section 2 of [RFC9545], a PSID is used to identify		As specified in Section 2 of [RFC9545], a PSID is used to identify
	the following:		the following:
	* a single segment list, some segment lists, or all segment lists in		* a single segment list, some segment lists, or all segment lists in
	a candidate path of an SR Policy,		a candidate path of an SR Policy,
	* some segment lists across multiple candidate paths of an SR		* some segment lists across multiple candidate paths of an SR
	policy, or		Policy, or
	* all segment lists in all candidate paths of an SR Policy.		* all segment lists in all candidate paths of an SR Policy.
	Therefore, six different Target FEC Stack sub-TLVs need to be defined		Therefore, six different Target FEC Stack sub-TLVs need to be defined
	for PSID. The ordered list of selection rules for the six Target FEC		for PSID. The ordered list of selection rules for the six Target FEC
	Stack sub-TLVs are defined as follows:		Stack sub-TLVs are defined as follows:
	* When a PSID is used to identify all segment lists in an SR Policy,		* When a PSID is used to identify all segment lists in an SR Policy,
	the Target FEC Stack sub-TLV of the type "SR Policy Associated		the Target FEC Stack sub-TLV of the type "SR Policy Associated
	PSID" (for IPv4 or IPv6) MUST be used for PSID checks.		PSID" (for IPv4 or IPv6) MUST be used for PSID checks.
End of changes. 1 change blocks.
	1 lines changed or deleted		1 lines changed or added
This html diff was produced by rfcdiff 1.48.